CHN10510

Operating Instructions (Continued)

is greater.. Use 1/4 inch air hose for runs up to 50 feet.. Use 3/8 inch air hoses for 50 foot run or longer..

150 psi or greater

3/8 inch I..D..

4.Use a pressure regulator on the compressor, with an operating pressure of 0 psi - 125 psi.. A pressure regulator is required to control the operating pressure of the tool between 60 psi and 100 psi..

Operational Mode

Always know the operational mode of

the tool before using. Failure to know the operational mode could result in death or serious personal injury.

Trigger Only Mode (with Trigger Lock)

The tool is a single-actuator device.. This mode requires that, with the trigger lock not positioned in the safe mode, only a pull of the trigger will fire a fastener..

2. Push the latch button.. Pull back on the magazine cover fully..

Latch

Button

3.Insert a stick of fasteners into the magazine with pins positioned as shown.. Make sure pins are not dirty or damaged.. Pins are marked for direction of loading..

4.Push the magazine cover forward until latch engages

Clearing A Jam From The Tool

1. Disconnect the air supply from the tool..

2.Remove all nails from the magazine (see "Loading/ Unloading The Nailer").. Failure to do so will cause the nails to eject from the front of the nailer..

3.Completely remove the two (2) small nose screws and the top nose plate to reveal the jammed fastener..

4.Using caution not to bend or damage the driver blade, use a pick or some other pointed object to pry free and clear the jammed fastener..

User-Maintenance

Instructions

Technical Service

Please call our Tool Hotline at 1-800- 543-6400 with any questions regarding the operation or repair of this tool or for additional copies of this manual..

Fastener And Replacement Parts

Use only 23 gauge headless micropins

(or equivalent - see Fastener Interchange Information). Tool performance, safety and durability could be reduced if improper fasteners are used. When ordering replacement parts or fasteners, specify by part number.

UnlockLock

After verifying there are no fasteners in the tool, safety check the operation of the activated trigger lock to prevent the tool from firing a fastener before storage.. Always disconnect from compressed air when not in use..

LOADING/UNLOADING THE TOOL

1.Set the pin length adjustment switch to the appropriate setting for the length of pins you are loading by first pushing in on the red switch and sliding until the notch is in the appropriate groove..

5.Always unload all fasteners before removing tool from service.. Unloading is the reverse of loading, except always disconnect the air supply before unloading..

Adjusting The Direction Of The Exhaust

The tool is equipped with an adjustable direction

exhaust deflector..Rotate This is intended to

allow the user to change the direction of the exhaust.. Simply twist the deflector to any direction desired..

Tool Repair

Only qualified personnel should repair the tool and they should use genuine Campbell Hausfeld replacement parts and accessories, or parts and accessories which perform equivalently..

DRIVER BLADE CARE and

REPLACEMENT

In order to properly drive the tiny micropins and leave a nearly undetectable hole, the tips of the driver blades end in a fine point and are therefore quite vulnerable to abuse and extended use..

www.chpower.com

5