Operating Instructions and Parts List | PW1350 |
13.The power cord on this product contains chemicals, including lead, known to the State of California to cause [cancer and] birth defects or other reproductive harm. Wash hands after handling.
14.To reduce the risk of injury, close supervision is necessary when a product is used near children.
Risk of electrocution
•Inspect cord before using - Do not use if cord is damaged.
•Keep all electrical connections dry and off the ground.
•Do not touch plug with wet hands.
•This product is provided with a ground fault circuit interrupter built into the power cord plug. If replacement of the plug or cord is needed, use only identical replacement parts.
•Do not spray electrical apparatus and wiring.
Risk of injection or sever injury
•High pressure. Keep clear of nozzle.
Do not discharge streams at persons or animals.
•Never put hand or fingers over spray tip while operating the unit.
•Never try to stop or deflect leaks with any body part.
•Always engage the trigger safety latch in the safe position when spraying
is stopped even if only for a few moments.
•Point gun in safe direction. Unit will start spraying when trigger is squeezed if “on/off” switch is in “ON” position.
•Discharge pressure – When “on/off” switch is in “off” position, pressure may still exist in unit. To discharge pressure, point gun is safe direction and squeeze trigger.
Risk of explosion
•Do not spray flammable liquids.
•Never use in areas containing combustible dust, liquids, or vapors.
•High pressure - Gun kicks back – Hold gun with both hands.
•Keep hose away from sharp objects.
Bursting hoses may cause injury. Examine hose regularly and replace if damaged. Do not attempt to mend a damaged hose.
•Use only detergents specifically formulated for pressure washers. Always follow detergent manufacturer’s label recommendations for proper use of detergents. Always protect eyes, skin, and respiratory system from detergent.
•For either indoor or outdoor use. Store indoors and where temperature stays above freezing.
•Unplug unit when not in use.
•Pressure washer is not meant to pump hot water. Do not connect to hot water supply.
•Never leave the unit unattended while it is plugged in.
•Always turn water supply “ON” before turning pressure washer “ON.” Running pump dry causes damage.
3www.chpower.com
