Operating Instructions and Parts List | PW1350 |
•Pressure washer is not meant to pump hot water. NEVER connect it to a hot water supply as it will significantly reduce the life of the pump.
•NEVER store the pressure washer outdoors or where it could freeze. The pump will be seriously damaged.
•Release trigger when changing from high to low pressure modes. Failure to do so could result in damage
Keep hose away from sharp
objects. Bursting hoses may cause injury. Examine hoses regularly and replace if damaged. Do not attempt to mend a damaged hose.
lock should be locked at all times when pressure washer is not in use.
The swivel adapter comes from the factory with 1 gasket installed on each side. Certain garden hoses require the use of this extra gasket to prevent water leakage.
Pump Gasket | Hose Gasket |
Extra Gasket
Figure 3 - Garden hose gasket instructions
Garden Hose Connection Instructions
1.Attach swivel adapter to pump water inlet, if not already attached. Notice the swivel adapter is marked with the words pump and hose. Make sure to connect pump side of adapter to pump water inlet to prevent damage to the threads.
2.Attach garden hose to swivel adapter side marked hose.
Swivel
Adapter
Garden
Hose
Figure 2 - Garden Hose Connection
3.The spray gun should be locked into the “OFF” position by locating the safety trigger lock just above the trigger of the gun. Activate the lock by holding the gun and push the lock from left to right. Squeeze trigger to make sure the trigger does not move. The safety trigger
Power Cord
1.Plug the power cord into a grounded 120V outlet and press the reset button as shown in Figure 4.
2.THIS MUST BE DONE EACH TIME THE UNIT IS PLUGGED IN AN OUTLET.
Reset
Figure 4 - Grounded plug/reset button
5www.chpower.com
