Campbell Hausfeld NB0040 Fasteners, Interchange Information, Troubleshooting Guide

Operating Instructions Model NB0040

Fasteners

The following Campbell Hausfeld brad nails are available at local retail stores. For help locating any item, call customer ser- vice at 1-800-543-6400. Campbell Hausfeld nails meet or exceed ASTM Standard F1667.

Model #	Length	Shank	Finish	Head	Collation	Nails Per	Nails Per
		Gauge				Stick	Box
FB001600	5/8”	18 Gauge	Galvanized	Brad /Brown	Adhesive	100	5000
FB002000	3/4”	18 Gauge	Galvanized	Brad /Brown	Adhesive	100	5000
FB002500	1”	18 Gauge	Galvanized	Brad /Brown	Adhesive	100	5000
FB003000	1-1/4”	18 Gauge	Galvanized	Brad /Brown	Adhesive	100	5000
FB004000	1-1/2”	18 Gauge	Galvanized	Brad /Brown	Adhesive	100	5000
FB004500	1-3/4”	18 Gauge	Galvanized	Brad /Brown	Adhesive	100	5000
FB005000	2”	18 Gauge	Galvanized	Brad /Brown	Adhesive	100	5000

Interchange Information

Nails used in the Campbell Hausfeld NB0040 Brad Nailer will also work in: Bostitch T31-1, T29-30, BT-35, BT50, Duofast BB4440, Hitachi NT45A , Paslode 2138-F40 , Porter Cable BN125, BN200, Sears 18409, 18424, and Senco SLP20, LS2, LS5.

Troubleshooting Guide

Stop using nailer immediately if any of the following problems occur. Serious personal injury could result. Any repairs or replacements must be done by a Qualified Service Person or Authorized Service Center.

Symptom	Possible Cause(s)	Corrective Action
Air leaking at trigger valve area	O-Rings in trigger valve housing are damaged	Replace O-Rings. Check operation of Work Contact
		Element (WCE)
Air leaking between housing	Loose screws in housing	Tighten screws
and nose	Damaged O-Rings	Replace and lubricate O-rings
	Damage to bumper	Replace bumper
Air leaking between housing	Loose screws	Tighten screws
and cap
Nailer skips driving nail	Worn bumper	Replace bumper
	Dirt in nose piece	Clean drive channel
	Dirt or damage prevent nails or pusher from	Clean and check magazine
	moving freely in magazine
	Damaged pusher spring	Replace spring
	Inadequate air flow to nailer	Check fitting, hose or compressor
	Worn O-Ring on piston etc.	Replace and lubricate O-rings
	Damaged O-Ring on trigger valve	Replace and lubricate O-rings
	Air leaks	Tighten screws and fittings
	Cap gasket leaking	Replace gasket
Nailer runs slow or has loss of power	Nailer not lubricated sufficiently	Lubricate nailer
	Broken spring in cylinder cap	Replace Spring
	Exhaust port in cap is blocked	Replace any damaged internal parts
Nails are jammed in nailer	Guide on driver is worn	Replace guide
	Nails are not correct size	Use only recommended nails
	Nails are bent	Replace with undamaged nails
	Magazine or nose screws are loose	Tighten screws
	Driver is damaged	Replace driver
	Nails loaded incorrectly	Review Loading/Unloading section in this manual
Air leaking at trigger valve stem	O-Rings or seals are damaged	Replace O-Rings or seals

www.campbellhausfeld.com

5