Operating Instructions and Assembly Instructions
Airless Paint Sprayers
Cleanup for Changing Paints or Temporary Storage for More Than One Night (Continued)
Cleaning Hose and Gun
Allow the cleaning fluid to continue circulating for approximately 10 minutes.
7. Turn pressure to HIGH (completely |
clockwise). |
8. Turn prime/spray control to SPRAY/ |
ROLL position. |
9. If reversible tip is used, rotate spray |
tip to CLEAN position. |
10. Point spray gun into bucket of |
paint and pull trigger. |
NOTE: To reduce splashing, direct |
fluid stream along inside of bucket |
and above the paint level. |
11. As soon as cleaning fluid is flowing |
from spray gun, release trigger. |
NOTE: It should take less than one |
minute to clear each 25 feet of high |
pressure hose. |
12. Engage gun trigger lock. |
13. Turn prime/spray control to PRIME |
position. |
14. Turn pressure control to HIGH. |
15. Lift suction assembly above fluid |
level in bucket. |
NOTE: Allow pump to run until |
empty. |
16. Repeat process (1 - 15) with |
fresh cleaning fluid, to remove |
contaminated cleaning fluid from |
7
Turn Pressure to HIGH (completely clockwise).
10
Paint
While Pulling Trigger,
Direct Fluid Stream Along
Inside of Bucket
8
9
Turn Prime/ Spray Control to SPRAY (knob
is vertical)
If Reversible Tip is
Used, Rotate Spray Tip
to CLEAN Position.
12
To Lock | Locked |
Engage Gun Trigger Lock
initial cleaning. |
13 | 15 |
14
Prime Position
High Pressure Position | Lift Suction |
(completely clockwise) | Assembly |
www.chpower.com
12