Operating Instructions and Assembly Instructions
Airless Paint Sprayers
Cleanup
cleanup for OVERNIGHT STORAGE
NOTE: Cleaning and maintenance of the pump are the most important steps you can take to ensure proper operation and a long life for your airless paint sprayer. Please follow the cleaning instructions carefully and . . .
WEAR ALL NECESSARY
SAFETY GEAR
Necessary Tools / Materials:
•One (1) bucket
•Water
•Plastic wrap
When reusing the sprayer with the same paint the next day at the same
job site, it is not necessary to flush the paint from the system. However, it is important to keep air from coming into contact with the paint.
NOTE: Do NOT disconnect any hoses.
1.Turn prime/spray control to PRIME position.
High pressure hose may still be
pressurized with prime/spray control in the PRIME position. With the gun pointed in a safe direction, pull the gun trigger to relieve any pressure in the hose.
Temporary Cleanup
1
Turn Prime/Spray
Control to PRIME
Position
3
Water
Place Gun in
Water
2
To Lock | Locked |
Engage Trigger Lock
4
Suction and Bypass Tubes Remain in Bucket with Ends Below Paint Surface
2.Engage gun trigger lock.
3.Place spray gun in bucket of water. There should be enough water to cover spray tip. This will prevent paint from drying or clogging tip.
4.Leave suction and bypass tubes in bucket of paint. Make sure ends of suction and bypass tubes are below surface of paint in bucket.
5.Cover bucket and tubes with plastic wrap or a damp towel to prevent film forming on paint. Or, if using latex paint, pour a very thin layer of water over top of paint. Stir water into paint the next morning.
5
PAINTor
Cover Bucket
PAINT
Latex Paint: Use Thin Layer of
Water to Cover Paint
www.chpower.com
10