Operating Instructions and Assembly Instructions
Airless Paint Sprayers
Spraying Instructions (Continued)
INTERMITTENT USE
If you are spraying and decide to stop for several minutes, lock the spray gun trigger and submerge the tip in a container of water (See Figure on page 8). This will prevent paint from hardening in the tiny spray opening and clogging the tip. Be sure to release the pressure in the system and turn the unit off.
CLEARING CLOGS
REVERSIBLE TIP: (Included)
1.Rotate the tip to the clean position (See Figure 1 on page 8).
2.Point gun in a safe direction and spray. This should clear tip of any blockage.
3.Rotate the tip back to the spray position and continue spraying (See Figure 2 on page 8).
4.If clogging continues, replace gun filter and consider straining the paint prior to use.
Equipment damage can occur if a needle
or sharp object is used to clean the tip. Tungsten carbide is brittle and can be chipped.
HOW TO CHANGE SPRAY TIPS
It may be necessary to change spray tips during a paint job. Follow these steps for safe, easy tip changes.
1.Depressurize and turn off unit per manufacturer’s instructions.
2.Engage gun trigger lock.
3. Pull red tip insert out of spray base and replace with different tip, fully
inserting tip into base.
HOW TO ATTACH ROLLER ACCESSORY
1.Depressurize and turn off unit per manufacturer’s instructions.
2.Engage gun trigger lock.
3.Remove spray base, tip, seal and washer assembly.
4.Attach roller accessory (AL2275 shown) to airless spray gun. If needed use thread adapter and washer between roller and spray gun as shown.
Figure - Attach roller accessory to spray gun
www.chpower.com