Campbell Hausfeld PW2802, PW3002 Service Record, Maintenance

Pressure Washer

Maintenance

Observe regular maintenance intervals to ensure maximum performance and life from the pressure washer. Refer to the schedule for recommended maintenance. If you operate the pressure washer in dusty conditions, perform maintenance checks more often.

ENGINE OIL CHANGING INSTRUCTIONS

Before tipping the

3.Drain old oil.

4.Replace the drain plug and set the unit upright.

5.Refill the unit with new oil of a recommended type and quantity. Fill the unit to the proper level shown on the dipstick (if provided). Otherwise, fill the unit to the top of the oil filler neck.

PUMP OIL CHANGING INSTRUCTIONS

Changing or refilling the oil in the pump requires removal of the pump from the engine and should not be required unless oil has leaked out due to worn or damaged oil seals in the pump. If oil has leaked out of the pump, bring the pressure washer to a certified Campbell Hausfeld service center for repair.

engine or equipment to drain oil, drain fuel from the fuel tank.

NOTE: Change oil while the engine is cool.

1.Disconnect the spark plug wire from the spark plug.

2.Locate, and if accessible, remove the engine oil drain plug (if the engine is equipped with an oil drain plug, the drain plug is located in at least one of the locations shown in Figure 18). If the engine oil drain plug is not accessible or if the engine is not equipped with an oil drain plug, tip the unit on its side to drain the oil out of the oil fill tube (See Figure 18).

NOTE: If draining oil from the oil fill tube, keep the air cleaner side up.

1. Oil fill tube

2. Plug on side of engine base

3. Plug at bottom

of engine

Figure 18 - Oil Drain Locations

Service Record

Date Maintenance performed Replacement components required

www.chpower.com

10