Operating Instructions | Model SB3232 |
General Safety Information (Continued)
Danger indicates
! DANGER an imminently haz- ardous situation which, if not avoided, WILL result in death or serious injury.
●Read and understand tool labels and manual. Failure to follow warn- ings, dangers, and cau- tions could result in DEATH or SERIOUS INJURY.
●Do not use any type
of reactive gases, including, but not lim- ited to, oxygen and
O
combustible gases, as CO2 a power source. Use filtered, lubricated,
regulated compressed air only. Use of a reactive gas instead of com- pressed air may cause the tool to explode which will cause death or serious personal injury.
●Use only a pressure- regulated compressed air source to limit the
air pressure supplied | 100 psi |
to the tool. The regu- | |
lated pressure must | MAX. |
|
not exceed 100 psi. If the regulator fails, the pressure delivered to the tool must not exceed 200 psi. The tool could explode which will cause death or serious personal injury.
● Never use gasoline or other flammable liquids to clean the tool. Never use the
tool in the presence of flammable liquids or gases. Vapors could ignite by a spark and cause an explosion which will result in death or serious personal injury.
● Always remain in a firmly balanced position when using or handling the tool.
●Do not remove, tamper with, or
otherwise cause the Work Contact Element (WCE) or trigger to become inoperable. Do
not operate any tool which has been modified in a like fashion. Death or serious personal injury could result.
●Do not touch the
trigger unless dri- ving fasteners. Never attach air
line to tool or carry tool while
touching the trig-
ger. The tool could eject a fastener which will result in death or serious personal injury.
Warning indicates
! WARNING a potentially hazardous situation which, if not avoid- ed, COULD result in death or
serious injury.
●Always discon- nect the tool
from the power source when unattended,
performing any maintenance or repair, clearing a jam, or moving the tool to a new location. Always reconnect the air line BEFORE load- ing any fasteners. Do not load the tool with fasteners when either the trigger is depressed or the Work Contact Element (WCE) is engaged. The tool could eject a fastener caus- ing death or serious personal injury.
●Always fit tool with a fitting or hose cou-
pling on or near the tool in
such a manner that all com-
pressed air in the tool is discharged at the time the fitting or hose cou- pling is disconnected. Do not use a check valve or any other fitting which allows air to remain in the tool. Death or serious personal injury could occur.
●Never place hands or any other body parts in the fastener discharge area of the tool. The tool might eject a fas- tener and could result
in death or serious personal injury.
●Never carry the tool by the air
hose or pull the hose to move the
tool or a compres- sor. Keep hoses away from heat,
oil and sharp edges. Replace any hose that is damaged, weak or worn. Personal injury or tool dam- age could occur.
Tool Components And Specifications
•REQUIRES: 0.8 SCFM with 10 fas- teners per minute @ 90 psi
•AIR INLET: 1/4” NPT
•FASTENER SIZE RANGE: 1/2” to 1 1/4”
•MAGAZINE CAPACITY:
100 fasteners per load, 18 gauge
•STAPLES: 1/4” crown
•WEIGHT: 2 lbs., 10 oz.
•LENGTH: 9 1/2”
•HEIGHT: 7 1/2”
•MAXIMUM PRESSURE: 100 psi
• PRESSURE RANGE: 60 - 100 psi
Work contact element (WCE)
Cap exhaust
Warning label
Latch button
Trigger
Magazine
Fastener discharge area
www.chpower.com
2
