qManual Exposure

You can set the flash output manually from full output at 1/1 to 1/64 output in full-stop increments. The flash can be fired in one of three ways: 1. A and B fired at the same output, 2. A and B fired at a different output, 3. Only A or B is fired. You should first take a test shot to check the exposure.

Firing A and B at the Same Flash Output

1

2

Select <q>.

Press the <D> button to display <q>.

Set the flash output.

Press the <a> button.

XThe flash output blinks.

ress the <h> or <i> button to set the flash output.

XEach time you press the button, the flash output will increase/decrease by 1 stop. Press the <a> button.

XThe flash output is displayed.

Firing A and B at a Different Flash Output

For step 2 above, follow the procedure below to set a different flash output for A and B.

1

2

Press the <f> button to display <yl>.

Select the flash tube/head.

Press the <b> button to select <1>, and the <c> button to select <2>.

3Set the flash output.

Press the <h> or <i> button to set the flash output. Pressing the <i> button to set the flash output to “--” will set only the other flash tube/head to fire.

XThe setting after 1/64 is “--”. The flash tube/head whose flash output has been set to “--” will not fire.

27