3Noise Reduction SettingsN
About [Multi Shot Noise Reduction]
The following functions cannot be set: AEB, WB bracketing, [z3: Long exp. noise reduction], 1+73/1. If any of these has already been set, [Multi Shot Noise Reduction] cannot be set.
Flash shooting is not possible. The
If you turn off the power or change the shooting mode to a Basic Zone mode, movie shooting, or bulb, the setting will change to [Standard].
If the images are greatly misaligned due to camera shake or if there is a moving subject, the noise reduction effect may be minimal.
If you are handholding the camera, keep it steady to prevent camera shake. Using a tripod is recommended.
The image alignment may not function properly with repetitive patterns (lattice, stripes, etc.) or flat,
Recording the image to the card will take longer than with normal shooting. During the processing of the images, “BUSY” will be displayed and you cannot take another picture until the processing is completed. [z3: Dust Delete Data] cannot be set.
If [Multi Shot Noise Reduction] is set, direct printing (p.280) is not possible.
If you play back a 1+73or 1image with the camera or print an image directly, the effect of the high ISO speed noise reduction may look minimal. Check the noise reduction effect or print
Long Exposure Noise Reduction
You can reduce noise in long exposures.
1Select [Long exp. noise reduction].
Under the [z3] tab, select [Long exp. noise reduction], then press <0>.
127