5

Press the

button, the

button or click the main dial.

• To cancel the compensation, return the setting to using the main dial or

the B or A arrow on the omni selector.

6 Shoot the image.

Compensating the Flash Output.

In mode or when [Flash Adjust] is set to [Manual], the flash output can be controlled in three steps, starting from FULL, when shooting. This setting is also active with slave flash photography where multiple flashes are fired at the subject from different positions because the pre-flash does not fire. When an externally mounted flash is attached, its flash output can be controlled (Up to 1/16 from Full, in 1/3 steps).

1 Press the button to turn on the LCD monitor.

2 Press the button.

3 Select using the C or D arrow on the omni selector.

4 Adjust the output using the main dial or the B or A arrow on the omni selector.

•You can shoot the image right after selecting settings by pressing the shutter button. This screen will appear again, once the image is shot.

e.g. Flash Output

5 Press the button, the button or click the main dial.

6 Shoot the image.

• Some settings are not available with certain Shooting modes. Please refer to Functions Available in Each Shooting Mode (p. 204).

Shooting - Selecting Particular Effects

101