Setting the Audio Mix

E

MIX

AUDIO BALANCE

MONITOR ST-1 ST-2

When you play back a tape that was recorded in 12-bit mode, you can set the audio output to stereo 1 (the original sound), stereo 2 (any new sound, dubbed to the tape after recording), or mix the balance between the two.

Audio from the 16-bit mode only contains stereo 1 sound and so you cannot/do not need to select the audio mix. The same applies to the 12-bit stereo 1 mode, unless new sound has been added post-recording.

+PLAY

TAPE (VCR)

Select the output channel.

Press AUDIO MONITOR on the wireless controller.

Starting with the last selected setting, 4 settings appear as you push the button:

STEREO1 for just stereo 1.

STEREO2 for just stereo 2.

MIX/FIXED for an equal mix of stereo 1 and 2.

MIX/VARI. (mix variable) for when you want to mix the balance between stereo 1 and 2.

If you choose MIX/VARI., you can go on to mix the balance.

Use the ST-1/ST-2 buttons to mix the balance. A bar showing the balance appears on the screen for 4 seconds.

Note:

• When you have chosen the output, STEREO1, STEREO2, MIX/FIXED or MIX/VARI. is shown in the

top left of the display for a few seconds. If you turn the power off, the output becomes set to

 

STEREO1.

Editing

 

111