Connecting the Scanner to Your PC
Connect the scanner with the following 1 to 5 procedures. The scanner can be connected to a computer in two ways. Select a connection method appropriate to your computing environment.
•“USB connection”…connecting to a standard USB port on the computer.•“SCSI connection”…connecting an SCSI card to one of the computer's expansion slots.
Turning On the Power (Scanner Recognition)
When you turn the scanner connected to the PC ON, the
1.
Turn OFF
Type B
1. | Turn OFF the scanner. |
| 2. Plug the power cord into the | |
| power connector of the scanner. |
| 3. Plug the power cord into the | |
| power outlet. |
4. | Turn OFF your computer |
| (when connecting by SCSI). |
5. |
|
Power Switch
ON Position
2.
| Connect the USB cable or the |
| SCSI cable to your computer. |
When the scanner is connected by an SCSI cable, always turn on the scanner before the computer. Turning on the computer first may prevent it from recognizing the scanner properly.
Log on to Windows with an account that has administrator privileges.
Wait at least 10 seconds before turning the scanner on again after turning it off.
5. SCSI cable | 3. |
(when connecting by SCSI) | Power cord |
4. Turn OFF
(when connecting by SCSI)
Type A
5. USB cable (when connecting by USB)
z When installation is finished, a balloon help
z The scanner is registered on the computer as “CANON
Selecting the Scanner
You must select your scanner before using it with an ISIS- or TWAIN- compatible scanning application or “CapturePerfect 3.0” installed on step 3.
When you select your scanner with the “Using CapturePerfect 3.0.” (p. 32)If you use another application, refer to the manual for your scanning application when selecting the scanner.
Do not use both a USB connection and an SCSI connection at the same time.
Use only the supplied power cord.
SCSI cable is not supplied. Acquire an SCSI cable beforehand that matches the shape of the connectors on your SCSI card and the scanner.
When using the scanner in a daisy chain connection with other SCSI devices, pay attention to the following points:
zThe default setting for the SCSI ID is “SCSI
ID=2.” Set the dip switches so that the scanner’s SCSI ID is different from all other SCSI devices on the chain.
zThe scanner has a
is permanently set to [ON]. When using the | OFF |
|
|
|
| SCSI ID | SW1 | SW2 |
scanner in a daisy chain connection, make |
|
|
|
| 2 | OFF | OFF | |
|
|
|
| |||||
sure that it is connected as the terminating | ON |
|
|
|
| 3 | ON | OFF |
1 2 |
| |||||||
device and that the terminators of all other |
|
| 4 | OFF | ON | |||
SCSI devices in the chain have been set to |
|
|
|
|
| 5 | ON | ON |
|
|
|
|
|
|
|
| |
[OFF].