Using AF to Focus (AF Method)
2 Focus the subject.
Press the shutter button halfway and the camera will focus the face covered by the <p> frame.
When focus is achieved, the AF point will turn green and the beeper will sound.
If focus is not achieved, the AF point will turn orange.
If a face cannot be detected, the AF point <
> will be displayed and AF will be executed at the center.
3 Take the picture.
Check the focus and exposure, then press the shutter button completely to take the picture (p.180).
If the focus is far off, face detection will not be possible. If the lens enables manual focusing even while the lens focus mode switch is set to <AF>, turn the focusing ring to attain rough focus. The face will then be detected and <p> will be displayed.
An object other than a human face may be detected as a face.
Face detection will not work if the face is very small or large in the picture, too bright or too dark, titled horizontally or diagonally, or partially hidden. The <p> may cover only part of the face.
You can press the <0> or <L> button to switch to FlexiZone - Single (p.192), and use <9> to move the AF point. To return to u(Face detection) Live mode, press <0> or the <L> button again.
Since AF is not possible with a face detected near the edge of the picture, the <p> will be grayed out. Then if you press the shutter button halfway, the center AF point <
> will be used to focus.
194