3Automatic Sensor Cleaning

When you turn the camera’s power switch on or off, the Self Cleaning Sensor Unit operates to automatically remove dust adhering to the imaging sensor. You normally need not pay attention to this feature. However, if you want to activate this self-cleaning manually or disable it, follow the instructions below.

Manual self-cleaning

Select [Sensor cleaning: Auto].

Under the [b] tab, select [Sensor cleaning: Auto], then press <0>. With [Clean now] selected, press <0>. The self-cleaning will be performed for about 1 sec., then the menu will reappear.

For maximum effectiveness, set the camera upright horizontally (do not tilt up or down) before executing [Clean now].

If [Clean now] is grayed out and cannot be selected, wait a while until it is selectable.

Disabling automatic sensor cleaning

With the screen above displayed, press the <U> key to select [Set up], then press <0>.

Press the <U> key to select [Disable], then press <0>.

To minimize dust from entering the camera, note the following countermeasures:

When changing lenses, do it in a place with minimal dust.

When storing the camera without a lens attached, be sure to attach the body cap.

Clean the body cap before attaching it.

111