1 - 37

#7 PRINTER
(Printer function settings) #1 SSSW
SW01
SW06
SW07~20:
SW20
Not used
Not used
Not used
Leading edge margin
Trailing edge margin (Black printing)
Not used
SUCTION
01: 18 (mm)
02: 0
03: 0
04: 0
05: 5(mm)
Item 06~30:
30:
––––––––
–––––100
Not used
SW02~05: Not used
76543210
Bit Not used
Reduction settings
#2 NUMERIC Param
#5 INK ABS CAPA
Yes=(-)
No=(+)
#4 PRINTER RESET
#3 PRINT COUNT XXX/YYY
Wasteinkcapacitycheck/entry
Printer section reset function
Print counter check
#6 GENESIS (UHQ)
(Genesis function settings)
1.Bit SW
2.SLICE
3.GAMMA
#6 CDR ADJUST
[
0
]:
CDR X SET
[
1
]:
CDR Y SET
Figure 1-28 Service Data (3/4)
Caution: #6 GENESIS (UHQ function settings)
Tampering with this setting may cause the scanned image quality to deteriorate.
Do not change these settings.
Memo:
#7 PRINTER (Printer function settings)
1. At #5 INK ABS CAPA, you can check or register the capacity of waste ink ejected during the
cleaning operation. For the waste ink capacity registration, register a value between 0 – 100
(%) with the numeric keys.
The absorption amount of the waste ink absorber is set based upon the amount that the BJ
cartridge has ejected.
The settings of the waste ink capacity are stored in EEPROM of SPCNT BOARD.
When replacing the SPCNT BOARD, check the waste ink capacity before the replacement,
and register the waste ink capacity at the new SPCNT BOARD after the replacement.
2. At #6 CDR ADJUST (CD-R Print writing position adjustment), you can adjust the writing
position in X and Y directions within the following range.
+/-0.0mm, +/-0.1mm, +/-0.2mm, +/-0.4mm, +/-0.6mm, +/-0.8mm, +/-1.0mm
You can also perform this adjustment from “CD-LabelPrint” or “Easy-PhotoPrint”.