External Connections

Transferring Video Recordings

You can transfer recordings to a computer using the DV terminal.

Equipment and System Requirements

•A computer equipped with an IEEE1394 (DV) terminal or an IEEE1394 (DV) capturing board.

•A DV cable. Use the optional CV-150F (4 pin-4 pin) or CV-250F (4 pin-6 pin) DV Cable.

•Video editing software.

•The appropriate driver.

A driver is preinstalled on Windows operating systems later than Windows 98 Second Edition and Mac operating systems later than Mac S 9, and will be installed automatically.

PC

onnecting

 

 

 

 

 

1

Start the computer.

2

onnect the camcorder to the

 

computer using the DV connection

 

–connection type 1 (

 

51)–

 

 

 

shown in

onnection Diagram.

3

Set the camcorder to

 

 

 

 

 

mode.

 

 

 

 

 

4Start the video editing software. Refer to the instruction manual of the editing software.

52

IMPORTANT

•The video transfer may not work correctly depending on the software and the specifications/settings of your computer.

•If the computer freezes while the camcorder is connected to it, disconnect the DV cable and turn off the camcorder and the computer. After a

short while, turn them on again, set the

camcorder to mode and restore the connection.

•Before connecting the camcorder to the computer using a DV cable, make sure that no other IEEE1394 device is connected to the computer.

•Depending on the video editing software, you may need to set the switch on the camcorder to a

mode other than LAY. Refer to the instruction manual of the editing software.

NOTES

•We recommend powering the camcorder using the compact power adapter.

•Refer also to the instruction manual of the computer.