2 Set Up the Machine

Connect Power Cord and Turn On the Machine

1 Connect the power cord into the rear socket on the back side of the machine and the wall outlet, and press the [I] side of the main power switch (A) to turn ON.

Do not connect the machine and the computer with a USB cable at this time. Connect the machine and the computer with a USB cable only during the software installation procedure. (A USB cable is not used when the machine is used via a network connection.)

2 The machine enters the standby mode.

1 0 0 %

L T R

 

 

 

 

T E X T / P H O T O

1

 

 

 

 

 

 

 

 

 

 

 

●The LCD display turned OFF:

The machine may enter the Sleep mode while you are performing setup. Press [Energy Saver] to turn the display back ON and continue the setup.

●<SET PAPER AGAIN/SET TONER AGAIN> is displayed:

Make sure that the toner cover and scanning platform are closed properly. (See “Install Toner Cartridge,” on p. 5.)

●<CLOSE COVER/TONER COVER> is displayed:

Check the installation of the toner cartridge and the placement of the paper. (See “Install Toner Cartridge,” on p. 5 and “Set Up Paper Cassette and Load Paper,” on p. 8.)

12