Attaching and charging the battery packs
CHARGE indicator
CHARGE
DC IN 9.5V
3
2 | 1 |
|
| P |
| E | R | ||
|
|
| MAC | O |
|
|
| E | |
|
|
|
| W |
| A | R |
|
|
|
|
|
| |
| O |
|
|
|
| F |
|
|
|
| F |
|
|
|
| P |
|
| |
| L |
|
| |
| A |
| ||
|
| Y( |
| |
|
|
| VCR) |
|
4
E
Your battery pack was partially charged before it left the factory. It should have enough power for you to check that your camcorder is working properly. However, you must charge the battery pack fully if you want it to power the camcorder for more than a few minutes.
Always turn the camcorder off before connecting/removing the battery.
1.Set the POWER switch to OFF.
2.Attach the battery to the camcorder.
•Remove the battery pack’s terminal cover.
•Align the edge of the battery pack with the line on the camcorder, press lightly and slide the battery down until it clicks into place.
3.Connect the power adapter to the camcorder.
4.Connect the power cable to the adapter and plug it into an AC outlet.
•The charge indicator flashes red to show that charging is in progress. Single flashes mean that the battery pack is less than 75% charged. Double flashes mean that it is more than 75% charged. The indicator glows steadily when the battery pack is fully charged. If the indicator blinks rapidly and continuously (twice a second), the battery pack may be defective.
•The battery pack will also charge when the POWER switch is turned to positions other than OFF. The CHARGE indicator may both flash or stay lit.
5.When charging is complete, disconnect the power adapter from the camcorder. Unplug the power cable from the AC outlet, then disconnect it from the adapter.
Mastering the Basics
13
