Trimming
You can cut out a portion of a recorded image and save it as a new image file.
| Choose [Trimming]. |
| ● Press the nbutton to choose [Trimming] |
| in the 1tab, then press the mbutton. |
| Choose an image. |
| ● Press the qrbuttons or turn the Âdial to |
| choose an image, then press the m |
Trimming Area | button. |
Trimming Area Display
Recorded pixels after trimming
XA frame will appear around the portion of the image to be trimmed.
XThe original image will display in the upper left and the trimmed image will display in the lower right.
●If you move the zoom lever to the left or right, you can change the frame size.
●If you press the opqrbuttons, you can move the frame.
●If you press the lbutton, you can change the frame orientation.
●In an image with detected faces, gray frames appear around the faces located in the upper left image. The frames can be
used for trimming. You can switch between frames by turning the Âdial.
●Press the mbutton.
●Follow Steps 4 and 5 on p. 128.
•Images recorded at a pixel setting of 
or 
(p. 71), or images resized
to 
(p. 128) cannot be edited.
•The width and height ratio of an image that can be trimmed is fixed at 4:3.
•The number of recorded pixels in a trimmed image will be smaller than before trimming.
129