Trimming
You can cut out a portion of a recorded image and save it as a new image file.
Choose [Trimming].
Trimming Area
Trimming Area Display Recorded pixels after trimming
∆Press the nbutton, choose the 1tab and [Trimming], then press the mbutton.
Choose an image.
∆Press the qrbuttons or turn the Âdial
to choose the image and press the mbutton.
Adjust the trimming area.
A frame will appear around the portion of the image to be trimmed.
The original image will display in the upper left and the trimmed image will display in the lower right.
∆If you move the zoom lever to the left or right, you can change the frame size.
∆If you press the opqrbuttons, you can move the frame.
∆If you press the lbutton, you can change the frame orientation.
∆In an image with detected faces, gray frames appear around the faces located in the upper left image. The frames can be
used for trimming. You can switch between frames by turning the Âdial.
∆Press the mbutton.
Save as a new image and display.
∆Follow Steps 4 and 5 on p. 130.
• Images recorded at a pixel setting of | or | (p. 72), or resized to |
(p. 130) cannot be edited. |
|
|
•The width and height ratio of an image that can be changed is fixed at 4:3 (for a vertical image 3:4).
•The number of recorded pixels in a trimmed image will be smaller than before trimming.
131