ID Mode
Selecting the Camera to be Controlled
<Example> As shown in the figure below, of 4 cameras (ID1 to ID3) only the cameras with ID number 2 (2 cameras) are selected for ID mode operation. In normal operation,
the camera LEDs turn green.
ID1ID2ID2ID3
Green Green Green Green
● Check the LEDs on all the adjacent connected cameras to ensure that all the
NOTE
cameras are receiving the signals from the wireless controller.
● Even if the cameras are switched off, when you press the i button the LEDs on all the cameras blink orange and you can begin ID mode operation. However, when a number button was pressed in step 2, the LEDs on cameras with ID numbers that do not match or that have not been assigned an ID number turn red and those cameras are switched off.
BRIGHTZOOM
T
W
HOME
SET/OKCANCEL
AF 1 2 3
MF | 4 | 5 | 6 |
∞ | 7 | 8 | 9 |
| |||
|
| 0 |
|
ON SCREEN Fn | ID | MENU |
1.Press the i button.
The LEDs on all the connected cameras blink orange (at
ID1 | ID2 | ID2 | ID3 |
Blinking orange Blinking orange Blinking orange Blinking orange
To cancel ID mode operation, press the c or i button. The LEDs on all the cameras then turn green.
2.Press a number button (in this case 2).
The cameras with ID2 are selected and the LEDs on only those cameras turn green. The LEDs on the other cameras turn orange (not blinking).
ID1 | ID2 | ID2 | ID3 |
Orange Green Green Orange
This completes the selection procedure. When you use the wireless controller, only the selected cameras will respond. When you press a button on the wireless controller, the LEDs on the selected cameras blink green (at
30