
Setting the Time Code
Selecting the Frame Setting
When recording in a mode other than SD at a frame rate of 24F, you can select between a drop frame or
MENU | SIGNAL SETUP |
| TIME CODE |
| FRAME SETTNG•DROP | |
|
| |||||
( | 25) |
|
|
|
|
|
|
|
|
|
|
|
|
Open the menu and select [SIGNAL SETUP]. Select the [TIME CODE] submenu and then [FRAME SETTNG]. Select a setting option and close the menu.
When you select the [NON DROP] setting or when you select 24F frame rate in SD mode, “NDF” will appear on the side panel display.
Selecting the Running Mode
When recording in a mode other than SD at a frame rate of 24F, you can select the running mode of the camcorder’s time code. You can enter the initial value for the
The time code runs only when recording. |
MENU | SIGNAL SETUP |
| TIME CODE |
| ||
|
| |||||
( | 25) |
|
|
|
|
|
1. Open the menu and select [SIGNAL SETUP]. Select the [TIME CODE] submenu and then
2. Select [SET].
The hours display flashes.
3. Set the time code’s initial value.
Turn the SELECT/SET dial to set the value for the hours and press the dial. The next field of the display starts flashing. Set the value for the minutes, seconds and frames in the same way.
4. Close the menu.
About the time code display
- | The time code will be displayed with an | R | next to it. | ||||
- | The time code will be displayed in blue with a |
|
| next to it. | |||
P | |||||||
- | The time code will be displayed in blue with an |
| next to it. | ||||
F |
- External Time Code: | The time code will be displayed in blue with an | E | next to it. | ||
- Time Code Hold: | The time code will be displayed with an |
| next to it. | ||
H | |||||
- Playback: | No time code display. |
When you select
To reset the time code to [00:00:00:00], select [RESET] in step 2.
42