
Recording Audio
Select the audio input from FRONT (supplied microphone), XLR MIC (XLR terminals) or XLR LINE (XLR terminals). You can select the audio input independently for channel 1 and channel 2.
Using the Front Microphone
Set the INPUT SELECT switch to FRONT MIC.
• You can select the microphone setting with the STEREO/MONO switch on the microphone itself. In the MONO position, the same monaural audio signal will be recorded on channels 1 and 2.
Using the XLR terminals
1. Connect a microphone to one of the XLR terminals.
• To supply a microphone with phantom power, set
the corresponding switch to N. Make sure to connect the microphone first, before turning the phantom power on. Keep the microphone connected when turning off the phantom power.
• Use commercially available microphones.
2. Set the INPUT SELE T switch to XLR MIC or XLR LINE.
3.Set the XLR REC CH SELECT switch to CH1 or CH1·CH2.
4.If necessary, turn on the microphone attenuator (20 dB) by setting the corresponding
switch to ATT.
The microphone attenuator will only be effective when the INPUT SELECT switch is set to XLR MIC.
5.If necessary, adjust the gain of the input signal. Open the menu and select [AUDIO SETUP]. Select [XLR 1 TRIM] or [XLR 2 TRIM], depending on the audio input you want
to adjust. Select a setting option and close the menu.
The gain adjustment will only be effective when the INPUT SELECT switch is set to XLR MIC.
When connecting a microphone that does not support phantom power, make sure to set the switch to OFF. Otherwise the microphone may be damaged.
58