Customizing the equalizer curve— EQ3 Tune

“Custom” of EQ3 allows you to make your own equalizer settings.

1Select a source, then press the multi way encoder.

2Rotate the multi way encoder to select “EQ3 parametric,” then press it.

3Rotate the multi way encoder to select “Custom,” then push it right.

4Rotate the multi way encoder to select “EQ3 Mode Tune,” then press it.

5Rotate the multi way encoder to select the desired frequency range from “LOW,” “MID” or “HI,” then press it.

6Rotate the multi way encoder to select the center frequency you wish to adjust, then press it.

Selectable frequency in each range: LOW: 60 Hz or 100 Hz

MID: 500 Hz or 1.0 kHz

HI: 10.0 kHz or 12.5 kHz

7Rotate the multi way encoder to adjust the equalizer curve.

The volume level is adjustable in 1 dB steps, from –10 dB to +10 dB.

8Press the multi way encoder.

Repeat steps 5 to 8 to adjust other frequency ranges.

9Push (BACK) down twice.

The display returns to normal play/reception mode.

To restore the factory-set equalizer curve, select “EQ3 Mode Initialize” and “Yes” in step 4.

Tip

Other equalizer types are also adjustable.

Adjusting setup items — MENU

1Press and hold the multi way encoder.

2Rotate the multi way encoder until the desired menu item appears, then press it.

3Rotate the multi way encoder to select the setting, then press it.

The setting is complete.

4Push (BACK) down.

The display returns to normal play/reception mode.

The following items can be set (follow the page reference for details):

“z” indicates the default settings.

SetupClock Adjust (page 4)Beep

To set “on” (z) or “off.”

RM (Rotary Commander)

To change the operative direction of the rotary commander controls.

–“NORM” (z): to use the rotary commander in the factory-set position.

–“REV”: when you mount the rotary commander on the right side of the steering column.

Auto Off

To shut off automatically after a desired time when the unit is turned off: “NO” (z), “30 sec,” “30 min” or “60 min.”

Display

Demo (Demonstration)

To set “on” (z) or “off.”

Image

To set various display images.

–“Movie 1 (z) – 3”: to display a movie.

–“SA 1 – 3”: to display the Spectrum Analyzer.

–“Wall.P 1 – 3”: to display a wallpaper.

–“off”: to not display any image.

Auto Image

To set various display images.

–“All”: to step repeatedly through the display images in all display modes.

–“Movie” (z): to display a movie.

–“SA”: to display the Spectrum Analyzer.

–“off”: to not display any image.

10