The Auto Off function does not operate.

The unit is turned on. The Auto Off function activates after turning off the unit.

tTurn off the unit.

Card remote commander operation is not possible.

Make sure the insulation film has been removed (page 4).

DSO does not function.

Depending on the type of car interior or type of music, DSO may not have a desirable effect.

The images change automatically.

In Auto Image mode, the selected image cannot be displayed.

tTo display selected image only, set to “Auto Image off” (page 10).

Any display items do not display.

tSet to “Info All” (page 11).

Cannot adjust the volume level

The portable audio device was not connected when AUX was selected as (SOURCE).

tConnect the portable audio device to the AUX input jack.

CD/MD playbackThe disc cannot be loaded.

Another disc is already loaded.

The disc has been forcibly inserted upside down or in the wrong way.

The disc does not playback.

Defective or dirty disc.

The CD-Rs/CD-RWs are not for audio use (page 14).

MP3/WMA/AAC files take longer to play back than others.

The following discs take a longer time to start playback.

a disc recorded with a complicated tree structure.

a disc recorded in Multi Session.

a disc to which data can be added.

The display items do not scroll.

For discs with very many characters, those may not scroll.

“Auto Scroll” is set to off.

tSet to “Auto Scroll on” (page 11) or press

(SCRL).

The sound skips.

• Installation is not correct.

tInstall the unit at an angle of less than 45° in a sturdy part of the car.

Defective or dirty disc.

The operation buttons do not function. The disc will not eject.

Press the RESET button (page 4).

Radio reception

The stations cannot be received.The sound is hampered by noises.

Connect a power antenna (aerial) control lead (blue) or accessory power supply lead (red) to the power supply lead of a car’s antenna (aerial) booster (only when your car has built-in FM/AM antenna (aerial) in the rear/side glass).

Check the connection of the car antenna (aerial).

The auto antenna (aerial) will not go up.

tCheck the connection of the power antenna (aerial) control lead.

Check the frequency.

When the DSO mode is on, the sound is sometimes hampered by noises.

tSet the DSO mode to “off” (page 9).

Preset tuning is not possible.

Store the correct frequency in the memory.

The broadcast signal is too weak.

Automatic tuning is not possible.

The local seek mode is set to “on.” t Set to “Local off” (page 11).

The broadcast signal is too weak. t Perform manual tuning.

During FM reception, the “ST” indication flashes.

Tune in the frequency accurately.

The broadcast signal is too weak. t Set to “Mono on” (page 11).

An FM program broadcast in stereo is heard in monaural.

The unit is in monaural reception mode.

tSet to “Mono off” (page 11).

Error displays/MessagesBlank Disc

Tracks have not been recorded on the MD.*1

tPlay an MD with recorded tracks.

Error*2

The disc is dirty or inserted upside down.*1 t Clean or insert the disc correctly.

A blank disc has been inserted.

The disc cannot play because of some problem. t Insert another disc.

Failure

The connection of speakers/amplifiers is incorrect.

tSee the installation guide manual of this model to check the connection.

Failure (Illuminates for about 1 second.)

When the SAT tuner is connected, storing an SAT radio channel into a preset failed.

tBe sure to receive the channel that you want to store, then try it again.

Load

The changer is loading the disc.

tWait until loading is complete.

Local Seek +/–

The local seek mode is on during automatic tuning.

18