do it yourself maintenance | 16 |
| |
|
|
WARNING! POWER FAILURE
In the event of a power failure, only the standard burners and grill can be lit manually. It is necessary to light each standard burner individually.
If the range is being used when the power failure occurs, turn all of the burner control knobs to the OFF position.
Holding a match at the ports, then by turning the control knob to the HI position, can light the standard burners and grill.
Wait until the flame is burning all the way around the burner cap before adjusting the flame to the desired height.
OVEN LIGHT AND BULB REPLACEMENT:
Replace only with a 30 Watt, 120 volt appliance light bulb. DO NOT USE a standard household light bulb in any oven.
To Replace The Light Bulb:
Turn the oven light switch to the OFF position. Let bulb and cover cool completely.
Remove the light cover by pulling gently on the corner of the glass with a standard flat tipped screwdriver, making sure not to exert more pressure than necessary (GLASS IS FRAGILE).
Remove the burnt out bulb. Replace it with a 30 Watt, appliance light bulb only!
Replace cover: Turn the circuit back on, if need be (see
Caution below).
CAUTION!
Before replacing the light bulb, be certain that the OVEN LIGHT SWITCH is in the OFF position. Let bulb and cover cool completely before touching. If the light bulb glass comes loose from the base, turn the power to the oven OFF at the circuit breaker panel, before attempting to remove the bulb base from the socket.
INTERMITTENT OR CONSTANT
IGNITER SPARKING
Intermittent or constant sparking of the sealed gas surface burners can result from a number of preventable conditions. Eliminate these conditions as indicated in the following chart.
SYMPTOM | CAUSE | REMEDY |
| Improper fit of burner cap |
|
Intermittent Sparking | into burner base | Seat cap in place. |
| Ceramic igniter is wet or | Carefully dry or |
| dirty | clean igniter. |
|
| Clean ports in burner |
|
| cap with a wire, a |
|
| needle, or |
| Knob is left in the LITE | straightened paper |
| position | clip. |
|
| Turn the knob to a |
|
| setting between HI |
|
| and SIM (LO on |
|
| earlier models) |
|
| Have a qualified |
| Range is not properly | electrician ground |
Constant Sparking | grounded | the range properly. |
|
| Refer to installation |
| Electrical power supply is | instructions for |
| incorrectly polarized | correct installation |
|
|
|