Capresso Avantgarde Series Clearyl Water Filter Cartridge, Activating, Select Product, Filter No

Least expensive: Decalcifying System (chapter 18.2, 18.3). Your machine is pre-set in the factory to automatically remind you to decalcify based on a water hardness of Level 2. You can change the water hardness setting to comply with the water you are using (chapter 15a).

Please note: The machine will automatically remind you when it is necessary to run certain water maintenance programs. It is important that you follow those instructions. Otherwise your machine might break down.

14. CLEARYL WATER FILTER CARTRIDGE

The machine comes with one Clearyl Water Filter Cartridge. The Clearyl cartridge

•Reduces the water hardness up to 75%.

•Removes (if present) up to 85% chlorine, up to 90% lead, up to 95% copper and up to 67% aluminum.

•Cleans the water through an upward current principle (Fig. 9) just before the brewing cycle starts, ensuring freshly filtered water every time you make coffee.

•Eliminates decalcifying except when using very hard water (25 grains or higher), see chapter 15. In this case we recom- mended to decalcify the machine once or twice a year.

•To reorder cartridges, see chapter 21.

14a. INSTALLING & ACTIVATING THE CLEARYL WATER

CARTRIDGE

Installing:

Important: Never install the cartridge before or during "Preparing Machine For The First Time" (chapter 6).

•Remove cartridge from its bag and rinse cartridge under water.

•Add the extension rod to the cartridge (Fig. 11).

•Remove the water tank, make sure it is empty.

•Pull up the cartridge holder and insert the cartridge with its tapered end down into the water container (Fig. 12, Fig. 13). Make sure it fits securely inside the fins. Push down gently (Fig. 13).

•Close the cartridge holder. Make sure the holder snaps into place.

•Fill the water tank with fresh cold water and replace.

Activating:

You must activate the cartridge otherwise the machine cannot monitor it properly and assumes that the machine is still in decalcifying mode.

SELECT PRODUCT

1.Push the Rotary Dial until you hear a beep. The display shows

FILTER NO

2.Push the Rotary Dial again, to enter the FILTER function. 3.Turn the Rotary Dial until the display shows FILTER YES and

push the Rotary Dial to confirm. The display shows INSERT FILTER/PRESS STEAM.

4.Place a 20 oz. container under the Steam Nozzle (Fig. 4) and push either steam button (Fig. 3, K or M). The display shows FILTER RINSING. For the next 60 seconds the machine will push water through the cartridge and out through the steam nozzle. Initially, the water may have a slight discoloration. The program will stop automatically. The display shows SELECT PRODUCT.

Please note: As long as the filter is activated, the water hardness setting is automatically turned off.

18.