Capresso Avantgarde Series Decalcifying Procedure Select Product/De-Scale Machine, Press Steam

Clearyl Cartridge. If the cartridge is in use for several weeks install a new cartridge.

Important: The decalcifying program must not be interrupted.

DECALCIFYING AGENT: Only use our special decalcifying tablets Model # 61848, see chapter 21.

CAUTION: Never use vinegar or any other decalcifying agent. This might damage internal parts of the machine.

CAUTION: Immediately remove any splashes or drops of the decalcifying solution from sensitive surfaces, such as natural stone or wood.

Always wait until the decalcifying solution in the water tank has been used up. Do not fill additional decalcifying solution into the water tank.

18.3DECALCIFYING PROCEDURE SELECT PRODUCT/DE-SCALE MACHINE

1.Push and hold the Rinse button until the following message appears EMPTY TRAY/EMPTY GROUNDS.

2.Remove and empty the tray and the used coffee container and replace TRAY MISSING.

Attention: If the tray and the used coffee container are empty, you need to remove the tray for approx. 20 seconds and then replace it. AGENT IN TANK/PRESS STEAM

3.Empty the Water Container. Remove the Dual Frother.

4.Dissolve 3 of the large square decalcifying tablets in a con- tainer with 20 oz. of water (0.6 liters) and pour the solution into the water tank. Replace water tank.

5.Place a large container under the steam nozzle (Fig. 4).

6.Push either steam button. The display shows MACHINE DE-SCALING. The lights in the Steam buttons start blinking. The machine will pump the mixture in intervals through the steam nozzle into the container underneath. After 10 minutes the machine "beeps". The display shows OPEN TAP.

7.Empty the container underneath the steam nozzle and place it underneath the hot water spout (Fig.1,14).

8.Turn the Selector switch to the hot water position (Fig. 3,L). The machine will now pump the mixture in intervals through the hot water spout. MACHINE DE-SCALING.

9.After approximately six minutes the machine will beep again. The display shows CLOSE TAP. Turn the

selector switch (Fig. 3,L) back to the cup symbol MACHINE DE-SCALING. The machine will now pump the remaining mixture in intervals into the used water tray inside. After another 12 minutes the machine "beeps" and the display shows EMPTY TRAY/EMPTY GROUNDS.

10.Carefully remove the used water tray (Fig. 1,18 ), TRAY MISSING empty it, rinse thoroughly and replace. The display shows FILL WATER TANK/RINSE WATER TANK.

11.Remove the water tank, rinse thoroughly, fill it halfway with fresh water and then replace. The display shows

PRESS STEAM.

12.Place a large container under the steam nozzle (Fig. 4).

13.Push either steam button. The display shows MACHINE DE-SCALING. For 2 minutes, it will pump fresh water in intervals through the steam nozzle into the container underneath. Then machine "beeps". The display shows

OPEN TAP.

29.