Capresso Z6, Z5 Eight Beverage Buttons, Beverage buttons are pre-set as follows

•Then attach the long Dual Nozzle System to the

Dial component (Fig. 5d). Please note: The milk nozzle should sit tight. The coffee nozzle must have a gap (Fig. 5e). Make sure the dial points to the cup with saucer for cappuccino (Fig. 5f).

•Attach the long hose to the dial component and insert the other end into a milk carton.

Thermal Milk Container: If you use the thermal milk container, attach the straight rod to the lid with the tapered end pointing to the bottom. Then insert the elbow rod through the top of the lid into the straight rod. Slip the open end of the short flexible hose over the elbow rod. Fill the thermal container with cold milk and assemble lid, thermal container and dial component. Important: Cold milk will stay cold for about 8 hours in the thermal milk container. Then the milk must be returned to the refrigerator or discarded. Remove lid when refrigerating. Rinse hoses and thermal container with hot water.

D) Eight Beverage Buttons

The Milk, Cappuccino and Special Coffee button brew through the ACS System (Fig. 5e). The Hot Water button brews through the hot water spout.

The beverage buttons are pre-set as follows:

				Coffee	Coffee
Button Function			Milk	Volume	Strength
Milk			20 sec	–	–
Cappuccino/Latte		*	15 sec	3.0 oz	NORMAL
Special Coffee		*	–	3.0 oz.	XSTRONG
Hot Water			–	6.0 oz.	–
1	Espresso	*	–	1.5 oz.	STRONG
2	Espresso	*	–	3.0 oz.	STRONG
1	Coffee	*	–	5.0 oz.	NORMAL
2	Coffee	*	–	10.0 oz.	NORMAL

* Temperature for coffee is set at HIGH.

•You can override Coffee Strengths just before brewing.

•You can override Cup Size during brewing.

•Overriding (chapter M) will not change above pre-sets.

•All pre-sets can be changed to new pre-sets (chapter N) Important: You can always stop any brewing by pushing the Rotary Dial or any beverage button.

Important: Never try to pull out the drawer while the Z5/Z6 is brewing or discarding. Always wait until the cycle is completed and the display shows COFFEE READY.