Place a 12 oz. container under the coffee spouts and an 8 oz. container under the nozzles of the
(Fig. 4) and drop one cleaning tablet into the funnel. Close the Ground Coffee Lid. PRESS BUTTON. Push the Rinse Button. MACHINE IS CLEANING. After a few minutes: TRAY GROUNDS EMPTY. Remove drawer. Empty used coffee container and drawer and replace all parts. COFFEE READY. The Z5/Z6 will automatically remind you when it’s time to run this cycle again.
S) Decalcifying Cycle
If you do not use the Clearyl water filter, the Z5/Z6 will remind you when to decalcify. For water hardness setting see Operating Instructions, chapter 24.
COFFEE READY DESCALE.
Important: If you use the Clearyl Cartridge and this message appears you did not activate the cartridge properly (no activation, see chapter O).
Important: Only use our special decalcifying tablet,
#61848 (see chapter U). Immediately remove any splashes or drops of the decalc mixture from sensitive surfaces, such as natural wood or stone.
Important: Do not interrupt program once started! Push and hold the Rinse Button until TRAY GROUNDS EMPTY. You must remove the complete drawer for 20 seconds, even if it is empty. Replace complete after emptying all parts. SOLVENT IN TANK. Remove and empty water tank. Dissolve 3 of the large square decalc tablets in a separate container with 20 oz. of water and pour the solution into the water tank. Replace water tank.
SOLVENT IN TANK PRESS BUTTON. Remove the Dual Nozzle System and the Dial Component and place one container underneath the spouts on the left side. Place another container under the Hot Water Spout. Each container should have at least an 8 oz. capacity. Push the Rinse Button. MACHINE IS DECALCIFYING. After approx. 35 minutes TRAY GROUNDS EMPTY. Remove the containers. Remove and empty the drawer system and replace. WATER TANK FILL. Thoroughly rinse and fill the water tank with fresh cold water, then replace. PRESS BUTTON. Place the two containers again underneath the spouts (see above) and push the Rinse Button. MACHINE IS DECALCIFYING. After a few minutes MACHINE IS HEATING. RINSING. Then TRAY GROUNDS EMPTY. Proceed as above.
