Carbine M9900DVDS manual Installation, Sheet, Screw, Washer, Metal Strap, Dashboard

Models: M9900DVDS

1 32
Download 32 pages 42.81 Kb
Page 25
Image 25
Installation

Installation

Step 1: The radio chassis is designed to be “Sleeve Mounted” through a opening in the dashboard panel. The required opening size is 182mm (7-3/16") x 84mm (3-5/16"). Cut or engage an opening in the dashboard to accommodate the mounting sleeve.

Step 2: Insert the mounting sleeve into the hole in the dashboard. Bend the metal tabs on the sleeve to secure the mounting sleeve to the dash- board.

Step 3: Bring all wiring for the connection of the unit (including the antenna) through the center of the mounting sleeve. Connect the wiring as follows:

Yellow Wire (w/Fuse): Connect this wire to a constant +12 volt power source (a power source that is not controlled by the ignition key).

Red Wire: Connect this wire to a switched +12 volt power source (a power source turned on and off by the ignition key).

Blue Wire: Connect this wire to the (+) power antenna activation circuit. If no power antenna exists, tape-off the end of this wire to prevent shorting out the unit.

Black Wire: Connect this wire to the frame of the vehicle (ground). This wire is the chassis grounding wire for the unit.

White Wire: Connect this wire to the Left Front Speaker (+) positive terminal or wire.

White Wire with Black Stripe: Connect this wire to the Left Front Speaker (-) negative terminal or wire.

Green Wire with Black Stripe: Connect this wire to the Left Rear Speaker (-) negative terminal or wire.

Green Wire: Connect this wire to the Left Rear Speaker (+) positive terminal or wire.

Gray Wire: Connect this wire to the Right Front Speaker (+) positive terminal or wire.

Gray Wire with Black Stripe: Connect this wire to the Right Front Speaker (-) negative terminal or wire.

Purple Wire with Black Stripe: Connect this wire to the Right Rear Speaker (-) negative terminal or wire.

Purple Wire: Connect this wire to the Right Rear Speaker (+) positive terminal or wire.

Note: This unit is designed to connect to (4) four speakers. If the installation only requires (2) two speakers, use the White and Gray wire sets to connect the speakers.

WARNING! Any wires left unconnected must be taped-off or capped off to prevent shorting. DO NOT connect speaker ground wires together.

DO NOT connect speaker ground wires to the chassis of the vehicle.

DO NOT connect front and rear speaker wires together.

FAILURE TO FOLLOW ANY OF THESE WARNINGS WILL RESULT IN DAMAGE TO THIS UNIT AND VOIDS THE WARRANTY.

 

 

 

 

 

Sheet

 

 

 

 

 

Metal

 

 

 

 

 

Screw

 

 

 

 

 

Nut

 

 

 

 

 

Washer

POWER

 

 

 

 

 

VOLUME

 

 

 

 

Metal Strap

 

PUSH

 

 

 

 

MENUSEL/

 

 

 

 

 

 

 

 

TUNE/TRACK

LOC

 

 

 

 

 

SCAN/SHIFT

 

 

 

Dashboard

 

MEMORY

 

 

EJECT

 

2

 

 

 

 

 

PRO G

 

 

 

 

 

RAM

 

 

ELAPSE

 

 

3

 

MOD

 

 

REPEAT

 

DIM

AS/PS

 

 

4

 

LOUD

/II

 

 

SHUFF

LE

MUT

 

 

 

 

 

 

 

5

 

 

 

 

 

SCAN

EQ

 

Mounting Sleeve

 

 

 

 

DISP

 

 

 

BAND

 

 

 

 

 

W-

 

 

 

 

BAN

 

 

 

 

 

25

Page 25
Image 25
Carbine M9900DVDS manual Installation, Sheet, Screw, Washer, Metal Strap, Dashboard