Speciality Features
Display Button: The factory default setting is clock display priority. Push the DISPLAY button at any time to display the radio frequency, CD track, AUX 1 or AUX 2.
Note: In the Sirius mode the factory default setting is Sirius channel display priority. Push the DISPLAY button at any time to display the
EQ DISP
Restoring Factory Default Setting: To restore the radio to the factory default setting:
1.Press the MODE button to select the radio band.
2.Push the BAND button and and hold until “EEP INIT” appears in the display. All settings will be restored to the factory default.
MODE AS/PS
ENTER
BAND
Reset Button: The radio panel or LCD display may fail to function normally due to the vehicle’s battery condition, and may require resetting the radio microprocessor if:
• The vehicle has been “jump started” from a dead battery condition.
• The vehicle battery becomes very low and is
• The vehicle battery is removed and replaced.
Should this condition occur, simply press and release the RESET button on the radio panel using the tip of a ball point pen. This will reset the radio microprocessor to the original factory settings. After pressing the RESET button you should recheck to see if the radio functions normally. All station programming should remain, but you will have to reset the clock. Should the LCD display area show any abnormal error code, please refer to the trouble shooting guide and solution chart below.
Error Code | Problem | Description | Possible Remedy | |
ERR 1 | Mechanism Problem | Unknown mechanical | 1. | Eject the disc and try another. |
|
| problem with the CD | 2. Press the reset button. | |
|
| mechanism. | 3. | Replace the unit. |
|
|
|
|
|
ERR 2 | TOC Reading Error | Laser can not read the | 1. | Insert a different disc. |
|
| CD disc table of | 2. | Check disc for excessive scratches. |
|
| contents. | 3. | Check disc for dirt and fingerprints. |
|
|
|
| Clean disc and reinsert. |
ERR 3 | Error from High | The temperature of the | Reduce the temperature inside the vehicle | |
| Ambient Temp. | mechanism is too high | and try to play a CD at a later time. | |
|
| to play CDs without |
|
|
|
| damaging them. |
|
|
|
|
|
|
|
ERR 4 | DVD Error | Error during playback | 1. | Insert a different disc. |
|
| of disc. | 2. | Check disc for excessive scratches. |
|
|
| 3. | Check disc for dirt and fingerprints. |
|
|
|
| Clean disc and reinsert. |
|
|
| 4. Press the reset button. | |
ERR 5 | Disc Error | Error during eject | 1. | Push the reset button. |
|
| and loading disc. | 2. | Replace the unit. |
|
|
|
|
|
|
|
|
|
|
23