GE JVM150J Questiom? Use This Woblem Solver, Problem Possible Cause and Remedy Oven will N~

m- Questiom?

Use This Woblem Solver

v

-

PROBLEM	POSSIBLE CAUSE AND REMEDY
OVEN WILL N~	o A fise in your home may be blown or~e circuit breaker tripped. Replace fuse or reset
COME ON	circuit breaker,
	● Unplug your microwave oven, then plug it back in.
	● Make sure 3-prong plug on oven is fully inserted into wdl receptacle.
CONTROL PANEL	● Door not securely closed.
LIGHTED, YET OVEN	● START must be touched afier entering cooking SelWtiOn.
WILL N~ ST~T	● ~other selection en~red ~ready in oven and cLEAR/oFF not touched to cancel it.
	● Make sure you have entered cooking time after touching TIME COOK I & II.
	● CLEAR/OFF was touch~ acciden~lly, Reset cooking program and touch START.
	● Make sure you have entered a temperature after touching TEMP COOK/HOLD.
	● Make sure you entered a code number after touching AUTO COOK, AU~ ROAST,
	AU~ DEFROST orAU~ REHEAT.
FOODS ARE EITHER	● Cooking times may vary because of starting food temperature, food density or amount
OVERCOOKED OR	of foods in oven. Touch TIME COOK I & H and additiond cooking time for completion.
UNDERCOOKED	o Incorrect power level entered. Check cookbook for recommended power level.
	o Dish ~s not ~~~, turned or stirr~. Some dishes require specific instructions.
	Check cookbook or recipe for instructions.
	G Too many dishes in oven at same time. Cooking time must be increased when cooking
	more than one food item. Check cookbook time recommendations.
	● Dish not completely covered as directed during Auto Cook.
	● previous micro~ving lefihu~idi~ or moistum in oven, thUS lessening the cooking
	time in Auto Cook finction.
	o Cemin vege~bles need a s~ding time after using Au@ Cook. Ch~k Automatic
	Cooking Control Guide.
	o probe not insefied properly into meat or dish when using Temp C~WHold or Auto
	Roast functions. Check cookbook for specific instructions.
“PRObE” APPEARS	* Probe has been forgotten or not seated properly in oven wall when using Temp
ON DISPLAY	CooWHold or Auto Roast.
“Error” APPEARS	o During Auto c~kor Auto Reheat program, the door was opened before SW could
ON DISPLAY	be detected.
	Ml these things are normal with your microwave oven:

●Steam or vapor escaping from around the door.

●Light reflection around door or outer case.

. Dimming oven light and change in blower sound may occur while

operating at power levels other than high.

●Dull thumping sound while oven is operating.

●Some TV-Radio interference might be noticed while using your microwave oven. It’s similar to the interference caused by other small appliances and does not indicate a problem with your oven.

If you need more help... call, toll free: GE Answer Center@ /800.6262000/ consumer information service

30