Next, remove the single screw located above door near center of oven that secures light housing. Replace
I | ., | I |
Clean off the grease and dust on hood surfaces often. Use a solution of warm water and detergent. About 1 tablespoon of ammonia may be added to the water. Take care not to touch the filters and enamel surfaces with this solution; ammonia will darken metal.
The Exhamt
Feature
When NIGHT LIGHT pad is touched, the hood light operates at a lower intensity for use as
a night light.
.
To remove grease filter, grasp the “finger hold” on the filter and slide to the rear. Then pull filter downward and to the front The filter will drop out.
II
To replace grease filter, slide the filter in the frame slot on the back of the opening.
Never operate your hood without the filter in place. In situations where flaming might occur on surfaces below hood, filter will retard entry of flames into the unit.
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a power cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded. (Fig. 1)
| INSURE PROPER |
| GROUNO EXISTS |
Fig. 1 | BEFORE USE |
|
Consult a qualified electrician or service technician if the grounding instructions are not completely understood, or if doubt exists as to whether the appliance is properly grounded.
ME+ALMETAL
FILTER I FILTER
COO~P/NIGHT LIGHT
The exhaust hood feature on your microwave oven is equipped with two metal fiIters which collect grease. When the fan is operated, air is drawn up through the filters and is then discharged through the
—provided venting to the outside. The hood also has a light for illuminating the counter space.
Pull filter upward and to the front to lock into place.
To clean grease filter, soak, then agitate filter in a solution of hot water and detergent. Don’t use ammonia or other alkali because it will darken metal. Light brushing can be used to remove embedded dirt. Rinse, shake and remove moisture before replacing. Filters should be cleaned at least once a month.
Where a standard
aproperly grounded
Do not under any circumstance cut or remove the third (ground) prong from the power cord.
Do not use an adapter plug with this appliance.
Do not use an extension cord with this appliance.
29