12
| SCALA RIDER® Q2™ Mult iSet
• Select the station you wish to replace by tapping the MC
button until you nd the station you want to replace.
• Search for a new station as described above.
• Tap the MC Button within 20 seconds of nding the station to
save the current station.
If you don't save the station, the Radio will exit search mode without
saving the current station. You can still continue to listen to the
current unsaved station. Tapping the MC Button in this case will
move to the next saved station.
USING THE MP3 PLAyER WITH yOUR HEADSET
Your SCALA RIDER headset can be connected to an MP3 player/audio
device by simply plugging it to the Helmet Clamp’s jack with the
audio cable as follows:
1. Power on the headset to have it on
Standby mode, ashing slowly in Blue.
2. Connect one side of the audio cable
to your MP3 player/audio device’s
jack and the other side to the helmet
Clamp’s jack as shown in the photo.
3. Operate the MP3 Player/audio device by
using its buttons (FF/REW/PLAY/PAUSE).
NOTE: Volume can only be adjusted through the MP3 Player.
Any other audio connection (Phone call/FM Radio/Intercom
call) will automatically mute the MP3 Player. The audio signal
will return only when headset is once again in Standby mode.
SUPPORT
For additional information please visit our website at
www.cardosystems.com
FAQ: www.cardosystems.com/faq
or contact us at:
support@cardosystems.com
Phone:
USA and Canada – + 1-800-488-0363
International – +4989 450 36819
NOTICES
Federal Communications Commission (FCC) Statement
15.21
You are cautioned that changes or modications not expressly approved by the part
responsible for compliance could void the user’s authority to operate the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Connect the audio cable to
the helmet Clamp’s jack