8
| SCALA RIDER® Q2Mult iSet
4. Use the pre -moistene d Towelette to clean the helmet
area where you want to inst all the Gl ue Plate. All ow to dry
thoroughly.
5. Peel the foil cover from the Glue Plates’ adhesive pad.
6. Place the Glue Plate into position according to #3. Press rmly 15
seconds on all 3 parts of the Glue Plate.
7. The adhesive pad bonds to full strength over the next 24 hours.
Therefore it is recommended to not use the headset during this 24
hour period.
8. Fasten the Clamp to the Glue Plate using the Allen screws that were
previously removed.
POSITIONING THE SPEAKERS
Attach the s peakers to the Velcro
inside your h elmet opp osite your ears
(short speak er cord for the lef t ear [A]
and the long speaker co rd [B] for the
right ear). You ma y want to u se the
supplied Velc ro pad.
Using two sp eakers insi de the he lmet may b e prohibit ed in
certain juri sdiction s. If this is the
case, you sho uld tuck away the
long corded s peaker und erneath
the helmet p adding as follows:
Lead the spea ker [B] al ongside th e
rim of the p adding to the right
side and then back to t he left
side, near sp eaker [A]. Th en place t he
speaker [B] un derneath the paddi ng.
ATTACHING AND REMOVING THE HEADSET FROM THE HELMET CLAMP
ATTACHING:
Slide the headset downwards along
the sliding panel until a clicking
sound indicates that the headset is
locked in place.
REMOVING:
Your headset can be remove d for
charging and s torage by p ressing
your finger g ently agains t the tab
and sliding th e headset u p with the
other hand.
We recommend that you remove the
headset from the helmet when not in use.
Press here to remove
Speaker A
Speaker B
Speaker B
Cable
Speaker A
Speaker B