Cardo Q2 STEP 3 SET UP FOR MOBILE PHONE CALLS: PAIRING , TO PAIR THE SCALA RIDER Q2 TO A BLUETOOTH MOBILE PHONE, STEP 4 SET UP FOR BLUETOOTH GPS DEVICE: PAIRING , TO PAIR THE SCALA RIDER Q2 TO A BLUETOOTH GPS DEVICE:

| SCALA RIDER® Q2™ Mult iSet

1. Place the SCALA RIDER Q2 into Intercom Pairing mode following

the instructions in the PRIMARY BUDDY PAIRING section above.

2. Once the Red Light begins ashing rapidly, press and hold Volume

up for three seconds.

3. The Red and Blue Lights will ash ve times, conrming that the

Reset Pairing was successful.

STEP 3SET UP FOR MOBILE PHONE CALLS: PAIRING

If you have a Bluetooth enabled mobile phone and would like to

make and receive phone calls using the SCALA RIDER Q2, you must

rst pair your headset to the mobile phone.

NOTE: If you have a compatible Bluetooth GPS device you wish to

use with the SCALA RIDER Q2, please skip this step, and continue

ahead to STEP 4: SET UP FOR BLUETOOTH GPS DEVICE.

Pairing is a o ne time pro cess. Once the headse t is paired to a

specific mob ile phone during thi s Setup Pro cedure, they will

remain paired a nd automati cally recog nize each o ther whene ver

they are withi n range. I f the conne ction be tween the phone an d

headset is los t, tap the CTRL b utton to re connect t he devices .

TO PAIR THE SCALA RIDER Q2 TO A BLUETOOTH MOBILE PHONE

1. Turn on your phone and make sure its Bluetooth function is

activated.

2. With the SCALA RIDER Q2 headset turned ON, press and hold

the CTRL Button for at least six seconds until the Red and Blue

Lights begin rapidly alternating.

3. Search for Bluetooth devices on your phone by following the

phone’s instructions. Please consult your phone’s User Manual

for more information.

4. After a few seconds the phone will list the SCALA RIDER

Q2 as a discovered device. Select it and follow your phone’s

instructions to accept the pairing.

5. When prompted enter 0000 (four zeros) as your PIN or passkey.

6. Your phone will conrm that pairing has succeeded and the

headset will begin ashing slowly in Blue.

NOTE: If the Pairing process is not completed within two minutes the

headset will return to Standby mode.

With some mobile phones, you may need to tap the CTRL button

to connect the headset to the phone after pairing is complete. The

SCALA RIDER Q2 headset will automatically connect to the last

phone connected to the headset.

STEP 4SET UP FOR BLUETOOTH GPS DEVICE: PAIRING

If you have a Bluetooth enabled GPS device and would like to transmit

navigation instructions and sounds from the GPS device through the

headset’s speakers, you must rst pair your headset to the GPS device.

NOTE: Not all Bluetooth enabled GPS devices allow connections to

Bluetooth headsets like the SCALA RIDER Q2. Please consult your

GPS device’s User Manual for more information.

TO PAIR THE SCALA RIDER Q2 TO A BLUETOOTH GPS DEVICE:

1. Turn on your GPS device.

2. With the SCALA RIDER Q2 headset turned ON, press and hold

the CTRL Button for at least six seconds until the Red and Blue

Lights begin rapidly alternating.