12 Models 336, 338 & 339Operating Procedures
Section 6 Operating Procedures
Each unit stores mix in a hopper. The mix then flows
by gravity through an air tube down into the freezing
cylinder. They all have 2.8 quart (2.6 liter) capacity
freezing cylinders. All models have 20 quart (18.9 liter)
mix hoppers.
Duplicate the following procedures, where they apply,
for the second freezing cylinder.
We begin our instructions at the point where we enter
the store in the morning and find the parts
disassembled and laid out to air dry from the prev ious
night’s cleaning.
These opening procedures will show you how to
assemble these parts into the freezer, sanitize them,
and prime the freezer with fresh mix in preparation to
serve your first portion.
If you are disassemblingthe machine for the first time
or need information to get to this starting point in our
instructions, turn to page 20, “Dis assembly”, and start
there.

Assembly

Note: When lubricating parts, use an approved f ood
grade lubricant (example: Taylor Lube).
MAKE SURE THE CONTROL SWITCH IS
IN THE “OFF” POSITION.
Step 1
Install the drive shaft. Lubricate the groove and shaft
portion that comes in contact with the bearing on the
beater drive shaft. Slide the seal over the shaft and
groove until it snaps into place.
DO NOT lubricate the hex end of the drive
shaft. Fill the inside portion of the seal with 1/4” more
lubricant and lubricate the flat side of the seal that fit s
onto the rear shell bearing.
Figure 3
Insert the drive shaft into the freezing cylinder, hex end
first, and into the rear shell bearing until the seal fit s
securely over the rear shell bearing. Engage the hex
end firmly into the drive coupling. Be sure the driv e
shaft fits into the drive coupling without binding.
Figure 4