Carrier 336, 338, 339 Closing Procedure, Draining Product From the Freezing Cylinder, Rinsing

19
Models 336, 338 & 339 Operating Procedures
Step 5
Press the “AUTO” button. The “AUTO” light will come
on indicating the main refrigeration system is
operating. When the unit cycles off, the product will be
at serving viscosity.
Figure 32
Note: The mix refrigeration light will come on,
indicating the mix refrigeration system is operating to
maintain the mix in the mix hopper.
Step 6
Fill the hopper with mix. As the mix level comes in
contact with the mix level sensing probe on the rear
wall of the hopper, the “MIX LOW” light will shut off.
Step 7
Place the mix hopper cover in position over the mix
hopper.
Repeat Steps 1 through 7 for the other side of the
freezer.
Closing Procedure
To disassemble your unit, the following items will be
needed:
STwo cleaning pails
SSanitized stainless steel rerun can with lid
SNecessary brushes (provided with freezer)
SCleaner
SSingle service towels
Draining Product From the
Freezing Cylinder
Step 1
Press the “AUTO” button, cancelling compressor and
beater motor operation.
Press the mix refrigeration button, cancelling the mix
hopper refrigeration system.
Step 2
Remove the hopper cover, hopper gasket and air tube.
Taket hese parts to the sink for cleaning.
Step 3
With a sanitized pail beneath the door spout, press the
“WASH” button. Lower the draw handle and drain the
remaining product from the freezing cylinder and the
mix hopper.
Step 4
When the flow of product stops, press the “ WASH”
button, and raise the draw handle. If local health codes
permit, empty the rerun into a sanitized stainless steel
can. Cover the container and place it in the walk-in
cooler.
Repeat Steps 1 through 4 for the other side of the
freezer.
Note: For the Model 336, both sides must be in
WASH. If one side is in AUTO and the other is in
WASH,the side t hat is in WASH will continue to freeze.
ALWAYSFOLLOW LOCAL HEALTH CODES.
Rinsing
Step 1
Pourt wo gallons (7.6 liters) of cool clean water int o the
mix hopper. With the brushes provided, scrub t he mix
hopper, mix inlet hole and mix level sensing probe.
Step 2
With a pail beneath the door spout, raise the prime plug
and press the “WASH” button.
Step 3
When a steady stream of rinse water is flowing from
the prime plug opening in the bottom of the f reezer
door, lower the draw handle. Drain all the rinse water
from the freezing cylinder, raise the draw handle and
press the “WASH” button, cancelling t he “WASH”
mode.
Repeat Steps 1 through 3 for the other side of the
freezer.