6.Release video screen from locked position. Lower video screen to viewing position for access to mounting locations in top of video system housing.
7.Raise video system into approximate position and connect all wiring to components. Route video cable through hole in mounting bracket. Connect wiring and cabling to video system per instructions included with video system.
8.Check function of all components and lights. See operating instructions for video system operations check. For further assistance, refer to the video system manual for the technical support phone number listed for your area.
9.Insert video system into opening in console. Note: Make sure that wires do not get pinched
between bosses on video system and console. Align holes in housing with threaded clips in mounting bracket. Loosely install four (4)
10.Raise video screen into locked position.
Figure 18
11.Install two (2 ) # 8 x 1 3/4" POH screws (item 8 pg 2) and two (2) # 8 finish washers (item 10 pg 2) in dimples at rear of overhead console to secure rear of console to plywood support installed above headliner. See Figure 19. Do not overtighten screws.
11
