6.Install video system wiring into vehicle. Route video system cables from installed position in center of roof to “B”-pillar. Down “B”-pillar to floor. Route power and ground leads forward to fuse box area. Connect power wire to a fused accessory controlled power source per instructions provided in video system. Ground negative lead to chassis. Route remaining wiring (RCA plugs, Remote sensor extension, etc.) to VCP location. Connect per instructions provided with video system. If video system is to be used as a television, install an appropriate antenna per instructions included with antenna. See Figure 7.
Figure 7
III.PREPARATION OF OVERHEAD CONSOLE.
1.Remove and retain OEM front control head bezel assembly by removing four ( 4 ) screws. See Fig. 8.
Figure 8
2.Remove and retain secondary light and pod assembly by removing eight ( 8 ) OEM screws. See Figure 9.
Figure 9
6
