Carson Optical 1181281, 1181280 Use caution to assure screw does not penetrate vehicle roof

3. Install block-off cover (item 16 pg 2) using one (1)

# 8 x 1 1/4" PWH screw (item 6 pg 2). See Fig. 4.

(Use caution to assure screw does not penetrate vehicle roof ).

Figure 4

4.Detach wire harness from brace where A/C assembly was removed. Remove and retain two (2) OEM screws. Trim headliner to clear front flange of rear mounting bracket (item 17 pg 2) Insert rear mounting bracket tabs in existing slots on rear of OEM brace. Align holes of bracket with OEM bracket. Secure with OEM screws. See Figure 5. Route wiring toward driver’s side of bracket. Install convoluted tube (item 11 pg 2) around wire harness to prevent chaffing against bracket.

Figure 5

5. Remove and retain two (2) OEM screws located at front of OEM bracket near windshield. Mount front bracket (item 13 pg 2) using OEM holes and OEM screws. See Figure 6.

Figure 6

5