Casablanca Fan Company 46U26D, 46U73M Installing The Blade/Blade Holder To Fan Motor, Preparation

CAPISTRANO

INSTALLING THE BLADE/BLADE HOLDER TO FAN MOTOR

PREPARATION

Step 8. To reach the blade holder mounting holes in the fan motor the dummy switch housing must be removed.

Take out the two 5-32 X 9/32” screws secur- ing the dummy switch housing and remove. Put the two (2) screws aside for the mo- ment, they will be used in Step 15 to install the switch housing after the blades are in- stalled.

The dummy switch housing is used only when shipping the fan.

Note: Save these two screws–they will be used in Step 15!

DUMMY

SWITCH HOUSING

MOUNT SCREW

5-32 X 9/32”

(2)

DUMMY

SWITCH HOUSING

BLADE & BLADE HOLDER HARDWARE

BLADE SCREW	BLADE HOLDER
(4 PER BLADE)
	SCREW
	(2 PER BLADE)

RUBBER GROMMET

(4 PER BLADE)

BLADE HOLDER

RUBBER GROMMET INSTALLATION

Step 9. Insert a rubber grommet through each blade hole of every blade. Inspect both sides of the blade to assure that the lips of the grommet are fully engaged.

CORRECT INSTALLATION

INCORRECT INSTALLATION

6