® 3 changing frequency setting
NOTE: All fans leave the factory set to
“1111”
You will only have to change the dip switch settings in the remote if you are using more than one fan in the same area and want to control them separately.
DIP
SWITCHES
NOTE: DO NOT set dip switch setting in the remote
to ‘0000’, this may cause frequency interference from other Casablanca Products.
Step 1. Turn power OFF at the circuit breaker or fuse box and at the toggle switch, for the fan you want to change.
Step 2. Remove the screws and switch plate from the existing switch box.
Step 3. Remove the screws holding the switch in the switch box.
Step 4. Pull the existing
Step 5. Change the dip switch settings, assuring that they are different from the previously installed
Step 6. Mount the
Step 7. At the circuit breaker or fuse box and at the toggle switch, turn the power off for the fan whose frequency you are changing.
Step 8. Within 20 seconds of restoring power to the ceiling fan and the
DIP SWITCHES | DIP SWITCHES |
SET TO ‘1111’ | SET TO ‘1001’ |
(Factory Setting) |
|
Automatic Demonstration Program
Programmed into every
To enter the demonstration program:
1.Turn off for at least 5 seconds. This will clear the fan memory ready for programming.
2. Turn | on. |
3.Immediately operate the buttons in the following sequence:
++++
A
•Lights slowly increase to full intensity.
•Fan accelerates to speed three with audio tones.
•Light dims to half intensity.
•Fan accelerates to full speed with audio tones.
•Fan reverses at full speed with audio tones.
•Fan operates at full speed.
•Fan turns off with audio tones (blades coast for a short time).
•Lights turn off.
The complete cycle lasts slightly over one minute. It
will continue to repeat until the is turned off for more than five seconds, cancelling the program.
19