Casablanca Fan Company 77xxD warranty Remove Switch Housing CAP Screws, Install Switch Housing

UTOPIAN

REMOVE SWITCH HOUSING CAP SCREWS

Step 12. Remove the two screws of the switch housing cap. Set the cap and screws aside for use in Step 15.

INSTALL SWITCH HOUSING

Step 13. Install 2 of the 3 switch housing screws onto the fan adapter plate, leaving 1⁄8" threads visible. Feed the wire connec- tor from the fan through the center of the switch housing.

Align the 2 screws on the adapter plate with the keyhole slots of the switch housing. Raise the switch housing, pulling on the fan wire connector to assure no wires get pinched.

Turn the switch housing counter clockwise, engaging the 2 screws. Install the third screw and tighten all 3 screws.

SWITCH

HOUSING SCREW

2 SWITCH HOUSING SCREWS

SWITCH

HOUSING

CONNECT WIRES

Step 14. Plug the wire connector for the fan into the wire connector for the switch housing. Assure that the clip from the fan connector engages the notch on the switch housing connector.

CLIPNOTCH

INSTALL SWITCH HOUSING CAP SCREWS

Step 15. If you are installing a light fix- ture, please refer to the “3-Speed Optional Light Fixture Installation” on the next page.

If no light fixture is being installed, care- fully push the wires and components back into the switch housing. Align the guiding pegs of the cap to the non-threaded holes of the switch housing. Reinstall the switch housing cap screws removed in Step 12.

8