UTOPIAN

CANOPY INSTALLATION

Step 2. Thread the wires from the ceiling through the opening in the canopy. Attach the canopy to the crossbar mounting bracket with three of the 8-32 x 21/4long canopy screws and canopy lock washers.

Using the screwdriver, tighten the screw firmly by hand only.

Note: On sloped ceilings, align the canopy opening toward the top or room peak.

CROSSBAR MOUNTING

BRACKET INSTALLED

CANOPY

CANOPY LOCK

WASHERS

CANOPY

SCREWS

HANGING THE FAN

Step 3. To hang the fan body in the canopy, hold the fan body firmly and in- sert the ball into the canopy opening. Check that no wires were pinched. Ro- tate the fan body until the slot in the ball fits into the pin opposite the canopy opening.

CAPPED

BLUE

D1-OPTION

WIRE

BALL

SLOT

PIN

CANOPY ELECTRICAL CONNECTIONS

Step 4a. Attach the fan wires to the ceiling fixture outlet box wiring by placing the bare ends of the wires side by side and then securing with a wire nut. Test that the connection is secure by pulling on the wire nut. Connect in this order:

Step 4b. Pull Chain Connections

GREEN leads from mounting plate and fan to GROUND con- ductor of power source. Secure with wire nut.

WHITE wire from fan to white NEUTRAL wire in ceiling fixture outlet box. Secure with wire nut.

BLUE wire and BLACK power wire from fan to BLACK power wire in ceiling outlet box. Secure with wire nut.

2 BLACK WIRES

2 WHITE WIRES

3 GREEN WIRES

WIRE NUT

5

Page 5
Image 5
Casablanca Fan Company 77xxD Canopy Installation, Hanging the FAN, Canopy Electrical Connections, Pull Chain Connections