UTOPIAN

PREPARATION INSTRUCTIONS

Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.

PERMA•LOCK™ HARDWARE

ALLEN SET SCREW

DOWNROD & BALL

14-20 x 14"

(PRE-INSTALLED)

3mm

ASSEMBLY

ALLEN WRENCH

FAN PREPARATION

CAUTION: Before trimming wires or installing the downrod, pull the wires on the bottom of the fan to assure they are all the same length as shown.

IMPORTANT SAFETY INFORMATION!

BEFORE STARTING THE INSTALLATION OF YOUR CEILING FAN, INSTALL THE THREADED DOWNROD INTO THE MOTOR COUPLING AND LOCK THE ASSEMBLY

Prepare for fan installation as follows:

Step A. Route the wires from the motor through the

Perma•Lock™ downrod and ball assembly.

Tip: The downrod has a tapered thread that is designed to lock completely when correctly installed.

Step B. Using the provided allen wrench, loosen the set screw several turns to allow installation of the downrod. Thread the downrod into the motor coupling until it stops turning, this will take at least four and a half full turns.

Step C. Securely tighten the set screw with the provided allen wrench to ensure safe operation of your fan.

CAUTION: Failure to fully lock in the down- rod before securely tightening the allen set screw may cause the fan to separate from the downrod during normal operation!

TAPERED

THREAD

ALLEN

SET SCREW

MOTOR WIRES

GROUND

WIRE

DOWNROD

&BALL

ASSEMBLY

MOTOR

COUPLING

3

Page 3
Image 3
Casablanca Fan Company 77xxD warranty Preparation Instructions, Permalock Hardware, FAN Preparation