Casablanca Fan Company 86UxxM Safety First, VERSATOUCH2 INSTALLATION, Standard Light Switch

Versa•Touch2®

SAFETY FIRST

Warning: To reduce the risk of electrical shock, this fan must be installed with an isolating wall control/switch.

VERSA•TOUCH2 INSTALLATION

	W-73
	control
W-73	holder		DRYWALL	wood	screw	screw
		12v BAttery	ANCHOR	screw	6-32 X 3/8”	6-32 X 1”
control			6-32 (2)	1” (2)	(2)	(2)

VERSA•TOUCH2 CONTROL BRACKET INSTALLATION

CAUTION! Do not use with wall dimmer.

standard

toggle switch

Inner

Mounting

holes

switch

cover plate

control bracket

Standard Light Switch

Step A. Remove the two screws holding the switch cover plate. Do not remove the cover plate.

Step B. Orient the control bracket as shown and line up the two inner mounting holes with those on the switch.

Step C. Install and tighten screws removed in Step A, by hand only.

Wall Installation

Step A. Locate a 2x4 wall stud in a convenient ­location.

Step B. Orient the control bracket as shown over the 2x4 stud.

Step C. Use the 1” wood screws in either the inner or outer mounting holes. Install and tighten screws by hand only.

tabs	Rocker
	Type
	Light
	switch

Outer

Mounting

holes

switch cover

controlplate bracket

Rocker Light Switch

Step A. Break off the two tabs by pushing outward.

Step B. Remove the two screws holding the switch cover plate. Do not remove the cover plate.

Step C. Orient the control bracket as shown and line up the two inner mounting holes with those on the switch.

Step D. Install and tighten screws by hand only.

Note: The wall anchors and 6-32 x 1” screws may be used in situations where mounting to a stud is not pos- sible. Use the inner mounting holes. After securing the anchor, discard the anchor’s pointed screws and use the 6-32 decor ovalhead screws supplied.

Anchor
Panhead
Screw	DRYWALL ANCHOR
wood	Decor Ovalhead screw
screw 1”	6-32 X 1”

Changes or modifications not expressly approved in writing by Casablanca Fan Co. may void the user’s authority to operate this equipment.

This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and

(2)this device must accept any interference, including interference that may cause undesired operation of the device.

11